Page 1 of 1

cutting with a zebra 105sl

PostPosted: Thu Aug 18, 2005 9:55 am
by Guest
Hi guys

After some infomration.

I have a sapscript that prints to a Zebra 105SL and have a requirement to cut the labels at certain points in the print, say change of customer.

I have been given the cut command as ~JK by zebra and the printer is set to delayed cut mode.

Problem is that the cut doesn't work. If I print say 2 labels with a cut after each, 2 labels are printed and no cut. If I then run it again a cut is made and 2 labels printed.

Any suggestions as to what I'm doing wrong

Stan...