Valuation Code in Measurment Reading

Logistics : PM and its sub-modules & SM

Moderators: Snowy, thx4allthefish, PJA

Post Reply
Sami li
Posts: 71
Joined: Wed Jan 29, 2003 12:50 am

Valuation Code in Measurment Reading

Post by Sami li » Tue Apr 05, 2005 9:37 pm

Dear all,

I have maintened catalogs for valuation code, but still I can't find it when I create measurement document. I have not found where is the link between catalog and measurement document in IMG. Could you please tell me what is the correct way to define valuation code for measurment reading?

Thank you very much!

Sami

Chudy
Posts: 306
Joined: Tue Feb 15, 2005 8:20 pm
Location: Australia

Post by Chudy » Tue Apr 05, 2005 9:52 pm

The link is in the "Define Measuring Point Category" - Catalogue type.
Tom

smt

Post by smt » Tue Apr 26, 2005 2:28 am

Step 1

Define catalog type in SPRO "define Measurement point category"

step 2

While creating the measurement point, add the required code group in the code group field. What code groups are made available for selection would depend on the catalog type selected in step 1

Hope this helps

SMT

SMRT

What is the use of the valuation code in the measuring point

Post by SMRT » Wed May 04, 2005 10:28 pm

smt wrote:Step 1

Define catalog type in SPRO "define Measurement point category"

step 2

While creating the measurement point, add the required code group in the code group field. What code groups are made available for selection would depend on the catalog type selected in step 1

Hope this helps

SMT
What is the use of the valuation code in the measuring point and measuring document? Can anybody clarify this functionality please.

Regards,SMRT

didier
Posts: 2409
Joined: Thu Apr 29, 2004 3:33 pm

Post by didier » Thu May 05, 2005 3:54 pm

for example, when your measurement is not a quantitative (number) , but some qualitative parameter.

e.g. for inspections :

e.g. : 1 = installation OK
2 : installation not OK : needs intervention of maintenance department
3 : check not done

Didier

Guestsgi

Meausring points

Post by Guestsgi » Fri May 06, 2005 2:35 am

In addition :

If you want to give additional qualitative information for measurement document or only the qualitative information then this functionality is used.

1. You have to mention the catalog type in IMG for Measuring point category.

2. In measuring point for an equipment you have to specify the codegroup.

3. When entering measurement docs the valuation code can be selected.

SGI

Post Reply