This website is not affiliated with, sponsored by, or approved by SAP AG.

cutting with a zebra 105sl

Development SAPscript/ Smartforms

Moderators: Snowy, thx4allthefish, YuriT, Gothmog

cutting with a zebra 105sl

Postby Guest » Thu Aug 18, 2005 9:55 am

Hi guys

After some infomration.

I have a sapscript that prints to a Zebra 105SL and have a requirement to cut the labels at certain points in the print, say change of customer.

I have been given the cut command as ~JK by zebra and the printer is set to delayed cut mode.

Problem is that the cut doesn't work. If I print say 2 labels with a cut after each, 2 labels are printed and no cut. If I then run it again a cut is made and 2 labels printed.

Any suggestions as to what I'm doing wrong

Stan...
Guest
 

Return to SAPscript/Smartforms

Who is online

Users browsing this forum: No registered users and 3 guests





loading...


This website is not affiliated with, sponsored by, or approved by SAP AG.